How to make the water ring vacuum pump realize automatic water absorption?

Automatic water absorption, first to have the power to help the water absorption tool to achieve this process, for the water ring vacuum pump, we can also use the following methods to achieve its automatic water absorption:

1, water ring vacuum pump water storage can be placed near the pump, and make the bottom of the barrel slightly higher than the pump outlet; Or when a pool is built on the side near the pump room, the pool is lowered slightly to form a reservoir. Connect the bucket with the water filling hole in the pump body with a pipe. Before stopping the machine, fill the bucket with the water from the outlet pipe, and then automatically absorb water when starting next time.

2. Remove the muffler of the small engine and install a special waste drinking water device by using the exhaust gas of the engine to extract the air, so that the water ring vacuum pump can generate a certain vacuum degree. Operation, first start the engine, and then water waste water device handle down deposit, close the exhaust outlet, exhaust gas from the engine, through the exhaust gas jet speed is high, low pressure, thus producing suction effect.

3. Install a cylindrical water tank in front of the water ring vacuum pump, the top of which is hemispherical and protruding. A section of straw is installed in the middle of the cabinet.

The above several methods, can realize the water ring vacuum pump automatic water absorption, are using very simple physical knowledge, can be completed.

Vacuum pump for vacuum preservation
High pumping speed screw vacuum pump
Vacuum pump for alcohol concentration in the food industry